Daikin VRV Spare Parts and Service in Islamabad & Rawalpindi
When a Daikin VRV system stops cooling in an office, hospital, hotel, plaza or school, every hour of downtime costs money. AC Repair Service Man supplies Daikin VRV spare parts Islamabad and provides expert repair, maintenance and AMC service across Islamabad and Rawalpindi, from Blue Area and the F, G and I sectors to Saddar, Bahria Town and DHA. We do not just sell parts. Our technicians find the actual fault first, then fit the right part, so you do not pay for replacements you did not need.
Call or WhatsApp: 0342-2617324 | Open: Mon–Sun, 8:00 AM–10:00 PM | Emergency support available

Daikin VRV Spare Parts Islamabad & Rawalpindi
We stock and arrange parts for Daikin VRV III, VRV IV, VRV 5 and older VRV models, for both outdoor and indoor units. If you need Daikin VRV spare parts Islamabad, send the model number and a photo of the unit label on WhatsApp and we will confirm availability.

1. Inverter Compressor
The compressor is the heart of the system. Signs of failure include repeated trips, high current draw, noise, weak cooling and error codes such as E5, E6 or L5. We test the motor windings, check oil condition and find out why the compressor failed before fitting a new one, because a compressor that fails from low oil or blocked piping will fail again.

2. Outdoor Inverter PCB
The inverter board controls compressor speed. Voltage spikes, load shedding and summer heat are common causes of failure. Typical symptoms are L4, L5, L8, L9 or P1 faults and a unit that will not start. We repair or replace the board and check the power supply that damaged it.

3. Main Control PCB (Outdoor) and Indoor PCB
If the system shows communication faults, random shutdowns or an indoor unit that does not respond, the main control board or indoor board may be at fault. We confirm with testing before replacing anything.

4. Fan Motor and Fan Blade
Outdoor fan motor failure often shows up as E7. Dust, bearing wear and capacitor problems are the usual causes. Indoor fan motors and swing motors are also available.

5. Electronic Expansion Valve (EEV) and Coil
A stuck or failed EEV causes poor cooling, icing or E9 faults. We supply the valve and coil and bring the system back to correct operating conditions.

6. Thermistors and Sensors
Discharge, suction, heat exchanger and outdoor air thermistors are low-cost parts that can cause serious-looking faults (J3, J5, J6, H9, C4, C5 type codes). Replacing a faulty sensor often fixes a system that appears badly broken.

7. Pressure Sensors and High Pressure Switch
For faults related to high or low pressure (E3, E4, F3), we test and replace pressure sensors and switches, and check the refrigerant charge.

8. Four-Way Valve, Solenoid Valves and Check Valves
For heat pump and heat recovery VRV systems where cooling or heating mode is not switching properly.

9. Drain Pump, Float Switch and Drain Hardware
Water leakage and A3 drain faults are very common in indoor cassette and ducted units. We supply drain pumps and float switches and clear the drain line.

10. Remote Controllers, Filters and Louvers
Wired and wireless controllers, central controllers, filters, vane motors and decorative panels.

11. Refrigerant and Compressor Oil
R410A and other refrigerants as required by your model, with proper vacuum, leak test and charging.
Daikin VRV Error Codes We Diagnose and Fix
The codes below are commonly seen on Daikin VRV systems. The exact meaning can vary slightly by model and series, so a technician should confirm with the service manual before any repair. We diagnose the fault and supply the Daikin VRV spare parts Islamabad needed to fix it.
| Error code | Usual meaning | Typical part involved |
|---|---|---|
| E1 | Outdoor PCB fault | Main control PCB |
| E3 | High pressure abnormality | Pressure switch, condenser, refrigerant charge |
| E4 | Low pressure abnormality | Pressure sensor, refrigerant leak, EEV |
| E5 | Compressor lock | Compressor, inverter PCB |
| E6 | Compressor overcurrent or startup failure | Compressor, inverter PCB |
| E7 | Outdoor fan motor fault | Fan motor, fan PCB |
| E9 | Electronic expansion valve fault | EEV and coil |
| F3 | Discharge pipe temperature abnormal | Thermistor, charge, compressor |
| H9, J3, J5, J6 | Thermistor faults | Thermistors |
| L4 | Inverter fin temperature rise | Inverter PCB cooling, fan |
| L5 | Inverter overcurrent | Inverter PCB, compressor |
| LC | Outdoor to inverter communication fault | PCB, wiring |
| U0 | Refrigerant shortage | Leak repair, recharge |
| U1 | Reverse phase or open phase | Power supply wiring |
| U2 | Power supply voltage problem | Power supply, inverter PCB |
| U4 / UF | Indoor to outdoor communication fault | Transmission wiring, PCB |
| A1 | Indoor PCB fault | Indoor PCB |
| A3 | Drain level abnormal | Drain pump, float switch |
| A6 | Indoor fan motor fault | Indoor fan motor |
